good but need instructions though

Respuesta de HSS ProService

Lo vende HSS ProService
La información de esta página se basa únicamente en reseñas sobre productos escritas por clientes de HSS ProService a través de Trustpilot.
good but need instructions though

Respuesta de HSS ProService
Ready well explained on how to use

Respuesta de HSS ProService
Does what’s required

Respuesta de HSS ProService
Great product

Respuesta de HSS ProService
Very good and reliable machine

Respuesta de HSS ProService
My builder didn't say there was any issue with the machinery

Respuesta de HSS ProService
Easy to use and sis the job

Respuesta de HSS ProService
it did the job

Respuesta de HSS ProService
Simple to use for anyone untrained

Respuesta de HSS ProService
Great item just right for the job I had to do

Respuesta de HSS ProService
Great clean tools and very helpful staff

Respuesta de HSS ProService
Best value

Respuesta de HSS ProService
Good Good

Respuesta de HSS ProService
Very effective and manageable for small areas.

Respuesta de HSS ProService
Brilliant for most time but seemed to tire easily and would not go along if there was a slight incline. But we had more or less finished by this time.

Respuesta de HSS ProService
HSS Tool hire , service is out class . Staff is efficient and very helpful. Although hiring amount was not much but they behave like a biggest deal. Instrument was also in perfect position.Staff also helped me, when un- loaded outside Selco. Anyhow it was a great experience of hiring from HSS.

Respuesta de HSS ProService
it wad in really good condition

Respuesta de HSS ProService
Does exactly what i needed it for

Respuesta de HSS ProService
Make easy work of the job

Respuesta de HSS ProService
This machine did a good job on the hardcore base for my shed, when it was running. I put down about 100mm of MOT1, in two approx equal layers, vibrating in between. then topped with about 20mm of sharp sand. Final surface was good enough to play snooker on, so no problems about the suitability. The plate is chamfered at the front to ride over bumps but when pulling the squared off plate back into sharper corners it gathers material making the corners higher. Same was obvious for the sides when turning corners sharply. Now the real problem... pull cord snapped on the second pull. Because it was knackered, not because i'm built like Popeye. Dismantled it and found both the recoil spring had jumped off or snapped and the cord pulley had part broken off and a previous repair. Rethreading it was tricky, and i had to remove the cover, manually rewind the cord and replace it each time i wanted to start the machine. Just very grateful that it started on the first pull each time. Not a bad machine, not poor quality, just badly maintained. Hence the middle rating

Respuesta de HSS ProService